Fixings & Metalwork

Square twisted nails; the recommended fixing for installation of joist hangers.

Nail length: 30mm
Nail gauge: 3.75mm
Average nail count = 350 /kg
Finish: Sherardised, service class 2

Cut point staples, typically used for attaching wire and netting to timber.

Staple length: 30mm
Staple gauge: 3.55mm
Average staple count = 260 /kg
Finish: Galvanised, service class 3

30mm Fence Panel L-Clip, a useful panel clip for discreet fixing that can only be seen from one side. Can also be used to fix gravel boards, as well as many uses as a general purpose corner bracket.

- Angle: 30 x 30mm
- Height: 50mm
- Galvanised Steel

Injection resin used for anchoring threaded bar into concrete, stone, masonry, brickwork and hollow masonry.

- One mixer nozzle supplied per 300ml tube, extra nozzles available to purchase separately
- Two part resin, apply in one single action with a caulking gun
- Suitable for indoor and outdoor applications
- Colour: Grey

These Stainless Steel lost-head screws are similar in size to a lost-head nail. They are designed to be used as a hidden fixing for tongue & groove flooring and timber cladding but are perfect for many other projects. Tongue-Tite Plus is intended to be installed at a 30-45 degree angle through the tongue of the board, allowing the groove to fit over the head of the screw. This screw can also be used to face-fix boards, the small head is barely visible when when driven just below the timber surface.

Tongue-Tite Plus is a stainless steel screw which is suitable for internal & external use. These screws have a narrow countersunk head with TX10 drive.
Its' single course thread has been designed to eliminate the ream out of the timber, giving high pull out retention, which helps to prevent squeaky floor boards.
The torx drive provides grip and control when fitting, the narrow countersunk head gives a neat flush fix to allow the next board to sit in place.

TX10 screwdriver bit included in the box.
Screw Head Diameter = 4.5mm