Anti-Rattle Panel Wedge

Rapid setting post hole concrete, suitable for fixing all types of wooden, metal and concrete posts.

Post Mix is a pre-blended, quick setting concrete mix, which sets in approximately 10 minutes after mixing with water (depending on ambient temperature).
Simply half fill the hole with water, then pour the post mix in.

Fencing contractors typically allow 1½ to 2 bags per fence post (this varies depending on the hole and post size).

We offer 33% discount on post-mix when you pay & collect in store!

45mm Fence Panel Clips; used to attach fence panels to wooden posts. Minimum of 4 clips needed per fence panel.

- Fits fence panels up to 45mm thick
- Galvanised Steel

The Wells fence panel is a good quality, well-made, decorative fence panel. It looks the same from both sides; perfect for shared boundaries. These panels are constructed with ‘hit & miss’ slats that allow wind to pass through. This panel has a smooth machined finish and is pressure treated green.

Height Including Trellis: 1800mm (approx. 6')
Width: 1800mm
Depth: 45mm

Please note this panel is 1800mm wide, not 1829mm (6’), you can increase the panel width to 1829mm by attaching panel packing strips, sold separately.

Concrete gravel boards slot between concrete posts to give fence panels a level surface to sit on. It is beneficial to use gravel boards if the ground is sloping; the gravel board is dug into the ground to create a level surface instead of digging in the fence panel. Raising the panel on a gravel board will help prevent rot caused by ground moisture, gravel boards also help to prevent damage to fence panels caused by lawn mowers and strimmers.

- Dimensions: 45mm x 150mm x 1829mm
- 20kg Each
- C50 Concrete (a strong mix)
- Two 5.5mm rebar set inside.

A self tapping bolt suitable for concrete, stone, brick, marble, wood and block (solid or hollow). Safe anchorage achieved without the need of high tightening forces. Can be removed and re-fixed into the same hole, providing the thread is correctly aligned. No expansion forces enables close to the edge fixing.

Drill Bit Dia. - 8mm
Anchor Length - 100mm
Washer Size - 10mm (M10)
Min Hole Depth - 55mm
Min Over Drill Depth - 15mm
Min. Embed Depth - 40mm
Max. Fixture Thickness - 60mm
Drill Bit Dia. for clearance - 10mm (to prevent binding when tightening bolt)
Head Type - Hex Head, 15mm (Across Flats)
Driver Type - Impact driver, socket, spanner
Max Tightening Torque - 40Nm

A self tapping bolt suitable for concrete, stone, brick, marble, wood and block (solid or hollow). Safe anchorage achieved without the need of high tightening forces. Can be removed and re-fixed into the same hole, providing the thread is correctly aligned. No expansion forces enables close to the edge fixing.

Drill Bit Dia. - 10mm
Anchor Length - 100mm
Washer Size - 12mm (M12)
Min Hole Depth - 70mm
Min Over Drill Depth - 20mm
Min. Embed Depth - 50mm
Max. Fixture Thickness - 50mm
Drill Bit Dia. for clearance - 12mm (to prevent binding when tightening bolt)
Head Type - Hex Head, 17mm (Across Flats)
Driver Type - Impact driver, socket, spanner
Max Tightening Torque - 60Nm