ex. 100 x 100mm x 2395mm Timber H Post - Flat Surface

New, untreated European Oak sleeper. A naturally durable sleeper without chemical preservative. Mainly used for landscaping projects; including raised beds and retaining walls but could have many other uses.

There are around 600 different Oak species, they aren’t all naturally durable. We only source Quercus Robur and Quercus Petraea which both have naturally durable heartwood.

These sleepers have a sawn finish, they are suitable for non-structural projects (not to be used as beams or lintels).

To understand the characteristics of Oak sleepers, please read our product specification guide in the downloads tab below.

Planed finish timber post cap for 100 x 100mm posts, pressure treated green. Protects post ends from weather and provides a smart finishing touch.

- Dimensions: 50mm (middle) x 125mm x 125mm
- Decorative chamfer on four sides
- Pressure treated
- Includes double ended screw (attached)

Rapid setting post hole concrete, suitable for fixing all types of wooden, metal and concrete posts.

Post Mix is a pre-blended, quick setting concrete mix, which sets in approximately 10 minutes after mixing with water (depending on ambient temperature).
Simply half fill the hole with water, then pour the post mix in.

Fencing contractors typically allow 1½ to 2 bags per fence post (this varies depending on the hole and post size).

We offer 33% discount on post-mix when you pay & collect in store!

Cross-cutting is where you cut across the grain of the timber to reduce the length.

We offer a cross-cutting service on our new Oak & treated softwood sleepers. All cross-cutting is to a tolerance of ±2mm. We are only able to offer 90° cuts.

Please note: Due to the size of our saw, you will lose 4mm per cut – if you were to cut three 600mm lengths from a 2.4m sleeper, the remaining offcut would be approx. 588mm long. Please keep this in mind when calculating your requirements.

We are only able to machine our own timber before it has left our yard. If you require a lot of machining, please contact us to discuss your requirements.

We are unable to accept returns on products that have been cut.

Concrete gravel boards slot between concrete posts to give fence panels a level surface to sit on. It is beneficial to use gravel boards if the ground is sloping; the gravel board is dug into the ground to create a level surface instead of digging in the fence panel. Raising the panel on a gravel board will help prevent rot caused by ground moisture, gravel boards also help to prevent damage to fence panels caused by lawn mowers and strimmers.

- Dimensions: 45mm x 150mm x 1829mm
- 20kg Each
- C50 Concrete (a strong mix)
- Two 5.5mm rebar set inside.

The Roma fence panel is a good quality, well-made, decorative fence panel. It looks the same from both sides; perfect for shared boundaries. These panels are constructed with ‘hit & miss’ slats that allow wind to pass through. This panel has a smooth machined finish and is pressure treated green.

Height: 1800mm (approx. 6')
Width: 1800mm
Depth: 45mm

Please note: This panel is 1800mm wide, not 1829mm (6’), you can increase the panel width to 1829mm by attaching panel packing strips, sold separately.